Wood master Flex Fuel Owner's Manual download pdf (Page 46)

Flex Fuel Owner’s Manual 2012

12: Bulk Materials Auto Mode

Check the Status Line(s)

Always monitor the current operating status which is displayed on the status line. It is only possible

to start the furnace in operating mode “Bulk materials auto control” when the operational status is “Boiler

 isswitchedo!”,“Stopsystem!”,“Stopsystem!Firebedmonitoring!”,“Availability”,“Heatexchangercleaner

 waitingtobereleased!”,or“Heatexchangercleaningisactive!”.Furtherdetailsonthestatuslinesare

given in section 12.7 .

Check the Insert

Check that the correct insert is installed in the rebox, and that the insert is free from any buildup that

may block air ow. Remove and clean the insert if needed. Below is the correct insert for this operating

mode.

12.3 Filling the Furnace

Note: Smoldering Gas Extraction is not available at this time. To vent the furnace to prevent ash from

exiting through the rebox door it is possible to turn on the fans via Output Tests - Boiler (Section 9)

and switch the draft fan on (Outputs 1 screen) while you load the furnace, then switch it o.

The lling procedure can begin providing change-over is permitted.

Note: The furnace will ALWAYS switch to “Bulk materials” after a successful ignition process. It is nec-

essary to switch back to “Bulk materials - auto control” every time it is to be used. Caution should be

used to ensure the furnace is cool enough to reload. If the furnace is not allowed to cool the materials

may self combust before the set time release.

First, place a few small pieces of kindling directly on

the insert.

Note: Ensure that the igniter tube is not blocked

by kindling. The igniter tube is located in the bot-

tom of the rebox right next to the insert on the

right side.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 75 76

No comments

Wood master Flex Fuel Owner's Manual Page 46